12-30-2013 08:25 AM
I recently added a new keyword and configured it as a processing filename keyword in Config. For ad-hoc imports, it prepopulates the keyword to the filename without any issues. However, we have an existing Client API solution that imports Word documents from a network share. I wasn't sure if this would prepopulate the keyword or not when archiving a new document without any changes to the code -- what I found was that it set all of the filename keywords to just "DOC" (only the extension, without the full filename).
I couldn't find anything in the SDK, but I wasn't sure if the Client API supported filename keywords when importing documents. If we were to manually set the filename value within the script, would we then end up with two keywords (one with the actual filename and one with just "DOC")?
Thanks,
Nick McElheny | Trover Solutions, Inc.
Lead Systems Engineer - Document Imaging
01-02-2014 07:34 AM
Daniel/Joe,
Thanks again for taking a look at this. I set up a test using the Client API today and it populated the filename successfully in both 9.2 and 13. There must be something else flaky going on with our existing API code. For now, knowing that it should work is sufficient.
Thanks again,
Nick McElheny | Trover Solutions, Inc.
Lead Systems Engineer - Document Imaging
01-02-2014 07:53 AM
Nick,
I am glad it worked for you! If you need anything else, dont hesitate to ask or call!
Find what you came for
We want to make your experience in Hyland Connect as valuable as possible, so we put together some helpful links.