topic Re: "amp-to-war" could not be activated because it does not exist in Alfresco Archive

"amp-to-war" could not be activated because it does not exist

ruyulin — Wed, 28 Dec 2016 02:41:41 GMT

hello everybodyI am using alfresco SDK componentX - repo sample project, using MVN command prompt：“[WARNING] The requested profile "amp-to-war" could not be activated because it does not exist.”How do I solve？The following is the executionD:\alfresco-extensions\componentX-repo>mvn clean install -

Re: "amp-to-war" could not be activated because it does not exist

kaynezhang — Wed, 28 Dec 2016 14:50:28 GMT

amp-to-war is used to deploy the amp to alfresco/share war.

If the amp is successfully packaged.,you can use mmt(modules management tool) tool to apply the AMP file to the alfresco/share war manually.

Re: "amp-to-war" could not be activated because it does not exist

ruyulin — Wed, 28 Dec 2016 15:09:09 GMT

             I see the official document said there are two ways of operation, thank you for your answer
            In addition:
            Alfresco SDK 2.2 can't use right now?
            I now use the alfresco SDK 3.0.4, this version perform run. bat, modify the code is also had to restart to take effect?
            If so, I should how to configure to let him take effect?

Re: "amp-to-war" could not be activated because it does not exist

kaynezhang — Wed, 28 Dec 2016 15:22:22 GMT

After you run mvn install
componentX-repo-1.0-SNAPSHOT.amp should be generated located at D:\alfresco-extensions\componentX-repo\target\componentX-repo-1.0-SNAPSHOT.amp
Then you can use mmt tool (modules management tool) to apply componentX-repo-1.0-SNAPSHOT.amp to alfresco.war.
It has same effect as amp-to-war parameter.
About how to use mmt tool ,please refer to http://docs.alfresco.com/4.2/concepts/dev-extensions-modules-management-tool.html.

Re: "amp-to-war" could not be activated because it does not exist

ruyulin — Wed, 28 Dec 2016 15:34:02 GMT

Now I have another question:
I run. Bat to run the project, modify the code to refresh the browser does not take effect, need to perform the run again. The bat. Is this how to solve?

I am in document configuration:
http://docs.alfresco.com/5.2/tasks/alfresco-sdk-rad-eclipse-hot-reloading.html

Re: "amp-to-war" could not be activated because it does not exist

kaynezhang — Wed, 28 Dec 2016 15:44:51 GMT

I'm sorry without further information I can't say what the reason is.

It might be alfresco-sdk-rad-eclipse-hot-reloading.html ,you can give it a try.

Re: "amp-to-war" could not be activated because it does not exist

ruyulin — Wed, 28 Dec 2016 15:47:22 GMT

好的谢谢